home.md

@@ -27,12 +27,12 @@ Pi Stand:
 * For added strength, apply a layer of epoxy to the intersecting edges of the face and the support. 
 * Attach the plastic nuts to the stand with epoxy. To do this, feed the screw through the front of the face and tighten the nuts down to the back of the face. Apply epoxy around the edges of the nuts, be careful not to get any epoxy on the screws. Once the epoxy dries, remove the screws. 
 
-image2b
+![alt text](https://git.cct.lsu.edu/mbless/AeolianWAVes/uploads/ddebb42dc73a7d2a9d203ab5025bddc6/2b.jpg)
 
 Amplifier:
 * You will need:
 
-image3 image4
+![alt text](https://git.cct.lsu.edu/mbless/AeolianWAVes/uploads/683af77810b55dc54fe2fdef97f5ed4c/3.jpg) ![alt text](https://git.cct.lsu.edu/mbless/AeolianWAVes/uploads/1e2b4ba557357f35ca4fd71f95dd9a75/4.jpg)
 
 * Feed the diode into the power slot on the amplifier. Make sure the diode is facing the proper way (the line should be touching the amplifier). Solder this connection and trim the excess wire from the diode. 
 
@@ -229,4 +229,4 @@ Program, Hang, and Enjoy:
 image43
 
 * You can easily program the wind chime by removing the cover plate from the bottom and making an ssh connection through the ethernet port. 
-* Hang the chime and power it on. Let the wind do the rest:![1]![1]![1]![1]![2]
\ No newline at end of file
+* Hang the chime and power it on. Let the wind do the rest:
\ No newline at end of file